Type: Anti Drip Nozzle
O-ring
O-ring
Body
Spring
Pin
Head
Ball
Maintenance Instructions:
• Check for plugged nozzles.
• Disassemble the nozzle/s as shown below.
• Set aside the o-rings and the ball. If necessary the o-rings and ball can be washed with slightly
soapy water.
• Soak the remaining metal parts in undiluted CLR® cleaner for a maximum of one hour.
• Once done soaking
rinse all parts thoroughly
and reassemble nozzles.
TIP:
If cleaning more than one nozzle, separate nozzles by type and size as you remove them.
Keep them separated during the cleaning process so reassembling and reinstalling after
cleaning will be much easier.
WARNING: Do not remove nozzles or plugs while system is running.
WARNING: Do not remove nozzles or plugs while system is running.
WARNING: Do not remove nozzles or plugs while system is running.
IS309-22G
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 6/6
End of Season & Winterizing:
Nozzles End of Season Care
• Remove from ring
•
Following
Maintenance Instructions
disassemble nozzles and clean them
• Reassemble nozzles
• Store nozzles in a container where they will not be exposed to freezing temperatures
Ring and Tube End of Season Care
• Do not reinstall nozzles at this time.
• Disconnect system from pump
• Using pressurized air, blow all water out of rings and tubes
Beginning of Season Setup:
Ring and Tube
• Cut off 1” of nylon tube, the amount that was previously inserted into the slip lock
(The pressure from the slip lock distorts the end of the tubing and it must be trimmed
off or it will not seal properly)
• Connect water to filter and pump system
• Run pump for 10 minutes to flush all tubing and rings
• Turn off pump
Nozzles
• Follow directions from
Step 5
on installing nozzles (
Hand tighten only
)
System
• Turn on pump and check system
