Barcode Scanning
XT2+
User Manual
Janam Technologies LLC Version 2, March 2019
Barcode Scanning 9—2
Scan Settings
Go to
Tools
>
Scan Set-
tings
to configure the
XT2+’s scan engine and
software. This is where
you set how the scanner
will work, how it will an-
nounce and communicate
results, what all the scan
operation settings should
be and, most importantly,
which of the numerous
code symbologies the
scanner should read.
Tab Section Option
Description
Basic
Scanning
Trigger timeout (sec)
Specifies the trigger time out in seconds. If a
barcode is not decoded within the specified
timeout, the default Notifier indicates that
decoding is failed.
Enable Auto Scan
Enable Auto Scan with specified interval.
Auto Scan interval
Set Auto Scan interval time.
Enable Cont. Scan
Enable Continuous Scan without any interval.
Wedge mode
Result Type
Select Result Type :
Keyboard Event
Clipboard(default)
Terminator
Select the desired barcode end method from the
pull down list.
Values: None, Tab, Space, LF
Notification
Beep
Enable Beep
Enable/disable beep and set volume.
Good read
Set sound to indicate good read.
Bad read
Set sound to indicate bad read.
LED
Enable LED
Set enable/disable visual scan indicators.
Vibrator
Enable Vibrator
Set enable/disable vibrator operation.
Good read
Set vibration time after good read.
Bad read
Set vibration time after bad read.
Wedge
Barcode ID
Transmit Barcode ID
Enable to transmit predefined barcode ID in
Detail tab.
Label
Prefix
Enter Prefix to be sent prior to the
decoded/received data.
Suffix
Enter Suffix to be sent after the
decoded/received data.
Character Set
Charset
Select desired character set.
Extd Wedge
Enable
Enable extended Wedge configuration.
Symbologies
Select barcode types you want to read.
There is “Enable All” and “Disable All” to enable/disable all symbologies.
About
Scanner
Shows scanner type and revision.
Application
Shows ScanSetting version.
Data
Factory reset
If after modifying settings you wish to return to
the factory defaults, tap Factory Reset.