Jammin Pro CRT.5, Instruction Manual

Page: 25 / 37

Your radio control model can
move at high speed and
therefore can cause injury to
people or damage property.
It is your responsibility to
operate your model safely.
For engine use, refer to the
manual included with the engine.
To prime the engine with fuel,
press down the primer button.
Attach one clip to the glow plug's
end and the other clip to one of
the cylinder cooling fins.
Quickly. pull the starter rope
(to start the engine).
For radio equipment, refer to
the manual included with the
radio.
Check that all screws and nuts
arc tight.
If the model begins to operate
by itself, there is someone
else on your frequency.
Do not try to operate your
model under these conditions
for it may go out of control.
Fill in the fuel.
Fully extend
transmitter antenna.
Switch on transmitter.
ON
ON
OFF
OFF
OPERATING YOUR MODEL SAFELY
Before Running Engine Start-Up While Running
After Running
Cautions for Safety
Switch on receiver.
Adjust by screwing the needle
little by little.
Remove the clips from the engine.
Check that the model turns in
proportion to the amount you
move the steering control of the
transmitter.
Check that the speed of the
model changes in proportion to
the amount you move the speed
control of the transmitter.
By pushing with your fingers the
air cleaner, interrupt the engine
Switch off receiver.
Switch off transmitter.
Proper maintenance extends the
life of the model.
Use genuine parts.
Do not run your model through
water. This may cause rust or
electrical problems.
If model does not operate
correctly stop it and find the
cause.
Check the batteries.
After each run, the model is hot.
Beware of getting burned.
Keep hands and tools away from
moving parts.
Never throw burning, gleaming
or smouldering things into fuel
cans even if these happen to be
empty.
This is very dangerous to life! I!