James SONIC D, User Manual, Page: 6 / 8

5) Setting the timer– When power is on, the timing setting figure will flash once
the option button has been pressed. This indicates that a time setting is
required. To set the timer, press the button to set the required cleaning
time (Minutes).
The ultrasonic's cleaning function will instantly start once the button is
pressed. The LCD display window displays “U” which represents that the ultrasonic
is working. Cleaning will stop automatically when the cleaning time (seconds)
and (minutes) has counted down to “00” on both sides. The figure will resume
the original setting automatically. This is the “memory function”.
6) Memory Function and Pause Function (= Start/Pause)--Every time
the Green Button is touched; the memory function will be activated to keep
the “MIN” figure in the memory (but not the “SEC”). When the timer stops
automatically, the memorized “MIN” figure will be remembered. It is convenient for
frequent users who repeat with same cleaning time cycle, as there is no need to
reset again and again. The Green Button is also a PAUSE function button allowing
you to pause the unit whilst the ultrasonic timer is still running, touch again
to release the pause and continue the operation ( need to RESET desired memorized
setting figure again after Pause function is used).
7) Use of degassing function: at the normal working state, the machine will start
degassing function once the button is pressed. Then, the LCD displays “D”.
Degassing function will stop once button is pressed again. Then, the LCD
displays “U”.
8) Red Button- This is the power switch for the machine. When you have finished
using the machine, touch to make sure that all of the displays have turned off.
Disconnect the unit from the mains supply and remove the power cable.
SONIC MX SERIES
Sweep:
Creates a wave amongst the cleaning
solution. Providing enhanced
cleaning of tubular items.
Power On/Off:
Primes unit for adjusting cleaning time. This
is then altered using + / – buttons above.
Start/Stop:
Starts and stops ultrasonic cleaner.
Degas:
Intermittent operation of ultrasonic
power for rapid removal of entrained
air from liquids.
Pulse:
Produces intense bursts of ultrasonic
power. Use to remove stubborn
contaminants or degas solution rapidly.
Power:
Adjusts the power rating of
the transducer.
Temp Dial:
Adjusts thermostat
of ultrasonic heating
element.
Timer Dial:
Sets duration of
cleaning cycle.
9 8