OPERATION
The device includes the OPS (Over Pressure Setting) function which allows
for the tyre’s pressure to be set very high and then reduced to the
pre-determined pressure. This is very handy for use when a new tyre is
fitted to a rim.
SETTING THE UNIT OF MEASURE:
This device has four units of measure that can be chosen by the user:
kpa - kilopascals
bar
psi. - pounds per square inch
kg / cm2 - kilograms per square centimetre
Once the unit is set, it will become the default unit for following usage.
1. Press (
i
) once the unit of measure starts to flash.
2. Press (
+
) or (
-
) to choose the unit.
3. Press Flat tyre/Confirm button to set the unit of measure.
SETTING OPS:
1. Press (
i
) twice, OPS will be flashing on the LCD screen.
2. Press (
+
) or (
-
) to choose the OPS value.
3. Press Flat tyre/Confirm button. If OPS value is not zero, OPS will be
displayed on the LCD screen.
I
NFLATION AND DEFLATION:
1. Press (
+
) or (
-
) to select target pressure.
2. Connect with tyre valve, ensure there are no air leaks and inflator will
start automatically.
3. When inflation is finished, the tyre inflator will stop automatically and
BEEP to notify that inflation has finished.
4. Disconnect the air hose from tyre valve.
PROGRAMMABLE BUTTONS:
1. Press P1 or P2 buttons once. Press (
+
) or (
-
) to select pressure desired.
2. Press the Flat tyre/Confirm button once and there will be a beep to
confirm the programmable button has been set to the desired pressure.
3. You can set each programmable button to a different pressure.
4. If the unit is turned off the programmable buttons will have to be
re-programmed.
FUNCTIONS:
1. Press ( i ) to enter the function setting mode. After selecting the unit of
measure, press ( i ) again to enter the OPS setting. Pressing the ( i ) button
three times and the device exit out of the function setting mode without
saving the selection.
2. When OPS function is on, the device will inflate to target pressure plus
OPS value first, then deflate to tyre pressure desired, for example: A final
target of 32 psi or 2.2bar with an OPS setting of 16 psi or 1.1bar gives
a sum of 48 psi or 3.3 bar. This sum of 48 psi or 3.3 bar is the Over
Pressure setting for the tyre. The tyre will inflate to the sum value and
deflate to the final target pressure.
3. If tyre pressure is lower than 3 psi or 0.2 bar, the device will not start
automatically. Press Flat tyre/Confirm button for 2 seconds to start
the inflator manually. And will inflate to the target pressure on the
LCD display.
4. During inflation, the device will check tyre pressure automatically, the
rolling bar shows inflation/deflation in progress and left to right means
inflating, right to left means deflating.
CONTROL PANEL
Reduce final target pressure
Increase final target pressure
Function Select: Unit change/OPS set
Flat tyre/Confirm button. Use this button to start the inflation process
when the pressure in the tyre is less than 3psi.
P1
Programmable preset button
P2
Programmable preset button
Fig. 1 Control panel
CONNECTIONS
1. Power cable
2. Air inlet
3. Air hose outlet
4. Exhaust
5. Buzzer (Audible warning)
DISPLAY
1. Unit of measure
2. Pressure display
3. Function selection
4. Rolling bar
2
3
4
5
Fig. 3 Display
PRODUCT IDENTIFICATION
Fig. 2 Connections
4
2
3
1