32
GB - Problems and solution
Problem
Solution
Transmitter and Quadcopter cannot be binded
Throttle position need to be minimized to zero.
Transmitter led blinks
Replace new AAA batteries
LCD transmitter is not showing the setting interface after
hold down the joystick for 1 second
Throttle not in zero position
Gyro not working well
Battery voltage lower
Re-binding
Land on to the ground for 3 seconds and take off again.
Electronic is overheated – Cooling down for at least 1 hour.
Unable to Flip because to less flip power
Press the cyclic joystick one time to enter into the expert(flip)
mode.
In the expert(flip) mode, the sensitivity on each channel should
be above 90%.
Quadcopter shaking with noise
Please check if the canopy, chassis and rotors transformed or the
chassis not firmly joint with canopy.
Switching between low and high rates on the transmitter is not
very user friendly.
Switch from expert mode to normal mode
Can not take off
Wrong installation on rotors, Rotors mark with A,B.please check.
Wrong installation on motors,please check if each motor installed
in correct position. See picture
The leg of the Quadcopter is easy taken apart
This is a special design to absorb the impact from hard crash,
Force the leg back to the joint position by hand as picture shows.
