JH 20T01 MIL Industrial Color Display
9
2.
The video controller is in the form of a video card (sometimes referred to as a
graphic card, video adapter, or graphics board) installed in a Nu-Bus or PDS slot.
Both configurations have a video connector. If you are not sure as to which connector is the
video connector, consult your computer or video card manual. To attach the monitor to your
system, follow the instructions below.
1.
Turn off the power to the display and computer.
2.
If necessary, install the video card. For more information, refer to the manual
accompanying the card.
3.
Connect the 15-pin mini D-SUB end of the MultiCable to the video connector of
your system.
4.
Connect one end of the power cable to the display and the other end to the power
outlet.
5.
Turn on the display and computer.
6.
This completes the installation.
NB! Some Mac computers require a cable adapter, consult your dealer.
6.4 Connection to Video cards
If your computer or video card is not compatible with the monitors preset signals or has a
different pin assignment, refer to the steps below to determine if your system is compatible
with the monitor.
1.
Turn off the power of the display and the computer.
2.
Determine the video connector’s pin assignment of your video card.
3.
Determine the output signal timing and level of your video card.
4.
Check the pin assignment and signal timing charts of the video card and make sure
the display accepts these pin assignments and signal timings.
5.
Connect the signal cable supplied with your video card to the display.
6.
Connect on end of the power cable to the display and the other end to a power
outlet.
7.
Turn on the display and computer.
8.
Adjust size and position of the image to your preference.
9.
This completes the installation.
Chapter 7 Display Adjustment Controls
7.1 Outside front panel controls
This display is provided with easy access main control for the user. On the display front right
side following controls are available;
Adjustment/control items Function/description
ON/OFF power switch
- turns the display power on or off. When the power is on, the
LED is lit.
