JAI TM-2016-8, Operation Manual

Page: 23 / 44

Page 13
TM-2016-8 and TM-2016-8CL Progressive Scan Shutter Camera
Installation
2.2.7 (b) JAI, Inc. Power Cables
If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out
diagram in “12-Pin Connector (TM-2016-8)” on page 6. The cable pin-out diagram is shown in
Figure 6 below. The color-coded leads use Gray for Ground and Yellow for +12V.
FIGURE 6.
12P-02S Interface Cable (optional)
Note: Make sure that the unused leads are not touching and that there is no possibility that
exposed wires could cause the leads to short.
2.2.7 (c) “K” Series Power Supplies
The “K” series power supplies are designed primarily for OEM users who will be mounting the power
supply inside a protective enclosure. For use in exposed situations, the PD-12UU series power supplies
are recommended.
1.
Attach the 110V line cord to the two terminals marked “AC.” Do not plug the cord into a 110V AC
socket until you have completed steps 1 through 3.
2.
Attach the Gray and Yellow leads of the power cable to the Ground and 12V DC terminals, respec-
tively.
3.
Replace the plastic terminal guard on the power supply.
2.2.7 (d) Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Section 2.2.2 (a on page 6. Connect the Ground lead to pin #1,
and the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient
current to properly power the camera.
2.2.7 (e) Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly
attach the power cable to the camera connector:
12P-02S Interface Cable
Pin# Lead Color Function Pin# Lead Color Function
1 Gray GND 7 Black coax VD Input
2 Yellow +12V DC 8 White coax shield N/C
3 Red coax shield GND 9 White coax HD Input
4 Red coax Video 10 Brown RXD
5 Orange coax shield GND 11 Blue Integration
6 Orange coax VINIT IN 12 Black coax shield TXD
HD In (White Coax)
Video Out (Red Coax)
VD In (Black Coax)
Power (Yellow)
+12 V
Analog
Frame Grabber
GND (Gray)
}
Jack