RM/TM-4200GE Series
12
Installation
Figure 1.
12-Pin Connector Pinouts.
Pin #1 is Ground and pin #2 is +12V DC. Table 1 shows the pin-out table.
Table 1
12-Pin Connector
Pin Description
Pin
Description
1 GND
7
VD in (CC4 equiv)
2 +12V
DC
8
Strobe Output
3 GND
(analog)
9
HD in (CC3 equiv)
4 Analog
Video
out
10
Reserved
5 GND
(digital)
11
Reserved
6
VINIT in (CC1 equiv)
12
Reserved
2.2.2 (b) Ethernet Connector
The GigE socket, marked on the camera’s back panel as “GigE,” is a standard RJ-45 Ethernet socket as shown in
Figure 2.
Figure 2.
GigE Ethernet Connector
Use at least Cat5e UTP cables (Cat6 cables are preferred). JAI recommends the use of shielded cables to
reduce emissions and for CE/FCC compliance. Double-shielded cables further reduce emissions.
2.2.3
Power Supplies and Power Cable Setup
2.2.3.1
Power Supplies
The TM-4200GE camera requires 12V DC power that is obtained through the 12-pin connector located on the
rear panel of the camera. JAI, Inc. power supplies feature a 100-240V AC/12V DC 1.2A universal voltage power
supply. JAI Inc. recommends the following power supplies:
PD-12UU
PD-12-UU(No Hirose 12-pin connector)
US plug
PD-12UUP
PD-12UU with 12-pin connector
US plug
PD-12UE
PD-12UU (No Hirose 12-pin connector)
European plug
PD-12UEP
PD-12UU with 12-pin connector
European plug
For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP power supplies
are available with the 12-pin mating connector already attached to the leads from the power supply. The PD-
12UU and PD-12UE power supplies can be connected to the JAI Inc. power cable either directly or using a
terminal strip.
