— 36 —
GO-2401M-PGE / GO-2401C-PGE
Line Status
The line status function allows you to verify the status of external input/output signals.
You can verify the status of the following signals.
•
Opt Out 1, Opt Out 2, Opt In 1
•
Time Stamp Reset
•
NAND Gate 0 In 1, NAND Gate 0 In 2, NAND Gate 1 In 1, NAND Gate 1 In 2
Shading Correction
The shading correction is a function that corrects non-uniformity (i.e., shading) in the amount of light
generated by the lens and lighting equipment. Using this function allows correction even if top, bottom,
left, and right shading is not symmetrical in relation to the center of the screen (H, V).
The size of the correction block is 16 (H) × 10 (V) blocks and calculation errors in the correction data
are minimized due to the small interpolation block. Each block is 128 × 128 pixels.
The total size of the blocks is 2048 (H) × 1280 (V), but the actual number of effective pixels for the
camera is 1936 (H) × 1216 (V). The ineffective peripheral areas will be deleted internally on the camera
automatically.
2048 (Total size)
1936 (Effective pixels)
1280 (Total size)
1216 (Effective pixels)
128
128
to
to
The following shading correction modes are available on the camera. However, as proper interpolation
is not performed when ROI settings are configured, execute shading correction at full size before
configuring the ROI settings.
■
Flat Shading
Correction is performed using the area of the screen with the highest brightness level as the reference,
and adjusting the brightness levels of the other areas to match this level.
