Tool change
Item no. 10200042, Revision 04
26 ( 36 )
10.2
Manual tool change
Example of design: Collet
1
Collet
The tool is clamped by tightening the collet. Proceed as follows:
Ü
Insert a suitable tool into the collet.
Ü
Clamp the tool by tightening the collet.
Ä
Recommended torque: 3 - 4 Nm
Ü
When doing so, only tighten the collet with the supplied collet screw-in
tool (ring wrench).
This minimizes collet warp and increases concentric run-out accuracy.
Note: Ensure functionality.
All contamination damages the collet, clamping nut, tool mount, etc. As a re-
sult, the function of the HF spindle is no longer guaranteed.
u
Clean the collet.
u
Clean the thread of the shaft.
u
Clean the inner taper of the shaft.
Ü
To change the collet, unscrew it fully.
