EN
53
STRADA HYBRID MM | MANUAL | 2023.02.28 | V.01
7.2. ADJUSTING THE WATER TEMPERATURE
MODE
15 sec
Adjusting the maximum water temperature for cooling
By reducing the water temperature setting, the unit will
start later. If the water temperature is set higher, the unit
will start sooner .
1 . Put the device in the cooling mode
2. Hold down the [Mode] and [+] simultaneously until the
last 4 LEDs start flashing .
Adjusting the minimum water temperature for heating
By increasing the water temperature setting, the unit will
start later. If the water temperature is set lower, the unit
will start sooner .
In combination with a heat pump, it may be necessary
to reduce the water temperature .
1 . Put the device in heating mode
2. Hold down the [Mode] and [+] simultaneously until the
last 4 LEDs start flashing .
4. The device returns to the selected mode. (±30sec).
3. Short press the [-] or [+] button to adjust the set temperature .
/
factory default water temperature
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
12
̊
C
18
̊
C
24
̊
C
14
̊
C
20
̊
C
26
̊
C
16
̊
C
22
̊
C
24
̊
C
30
̊
C
36
̊
C
26
̊
C
32
̊
C
38
̊
C
28
̊
C
34
̊
C
7.3. FACTORY RESET
1 . Disable power charge .
2. Press and hold down both the [-] and [+] button on the circuit board and switch on
the power again. The blue LED will light up, followed by the green LED 2 seconds
later and the red LED 4 seconds later. Release the buttons as soon as all 3 LEDs
are flashing .
3. The controller will return to the Factory Default settings, all LEDs will flash for 8
seconds .
-
