1 0 9 6 3 4
1
INSTALL WALL BRACKET
2
INSTALL ACCESSORY
1
Note: Installation is typical for all wall mounted accessories.
Robe Hook
Towel Ring
Soap Dish Clear
Tissue Holder
Tumbler Clear
Toilet Brush
Set
ROUGHING-IN
DIMENSIONS
1 0 9 6 3 4
Phillips Screwdriver
TOOLS REQUIRED
016/300 (11-13/16")
016/460 (18-1/8")
016/600 (23-5/8")
016/800 (31-1/2")
Robe Hook
Towel Ring
Tissue Holder
(hooded)
Tumbler Clear
Soap Dish Clear
Toilet Brush Set
Towel Bar
Shelf 24" Clear
Drill
Level
10'
Tape
Measure
2 -3/8" D.
5- 3/4"
2 -3/8" D.
15- 3/4"
5 -3/4"
23- 5/8"
4 -3/4"
6- 1/4" D.
7- 1/4"
5 -1/2"
1 -7/8"
2 -3/8" D.
2- 1/2"
2- 3/8" D.
1 -7/8"
2 -3/8" D.
5- 1/8"
3 -1/8"
2- 3/8" D.
5 -7/8"
2-3/8" D.
4- 1/8"
2- 3/8" D.
4 -1/16"
Regular Screwdriver
The wall mounted accessories work best if secured to a wall stud or cross brace within the wall, using the SCREW (1) supplied.
If the wall mounted accessories are to be installed on a tile or plaster wall the ANCHOR (3) and SCREW (1) should be used.
Secure MOUNTING POST (2) to wall with SCREWS (1).
Installation for two posted accessories are installed in the same manner but at the indicated dimension between the posts.
For installations on drywall or tiled walls:
Use ANCHOR (3) and SCREW (1) for securing MOUNTING POST (2) to finished wall.
Drill a 1/4" dia. hole a minimum of 1-3/4" deep. Insert the ANCHOR (3) flush with face of the finished wall.
Determine desired height and location (optional) and mark a center line. Using the MOUNTING POST (2) as a template mark the
spot for the ANCHOR (3). If MOUNTING POST (2) is secured to a stud or cross brace, drill small pilot hole for SCREW (1).
3
1
4
2
OPTIONAL TO
FINISHED FLOOR
1/4" DIA. HOLE
5
Install WALL MOUNTED ACCESSORY onto installed MOUNTING POST (2). Push WALL MOUNTED ACCESSORY flush against
finished wall and tighten SET SCREW (4) with HEX WRENCH (5) supplied to secure to wall.
2
3
1
OPTIONAL TO
FINISHED FLOOR
FINISHED
WALL
