3
INSTALL VALVE BODIES
4
INSTALL HANDLES
1-1/4'' MAX.
Thread LOCKNUT
(8)
to bottom of VALVE BODY
(4)
. Make sure
FIBER WASHER
(9)
and RUBBER WASHER
(10)
are installed.
Insert VALVE BODY
(4)
through mounting hole from underside
of SINK or mounting surface.
Note: VALVE BODY marked with Red Dot is installed in the left Mtg.
hole,VALVE BODY marked with Blue Dot in the right Mtg. hole
when facing front of fitting. Maximum mounting thickness is 1-1/4".
If HANDLES
(1 & 2)
and HANDLE BASE
(3)
are installed on
VALVE BODIES
(4)
they must be removed to install VALVE BODIES
(4)
from under lavatory or mounting surface.
To remove CROSS HANDLE
(1)
; Pull out INDEX CAP
(5)
and remove
HANDLE SCREW
(6)
. Pull off CROSS HANDLE
(1)
and unthread
HANDLE BASE
(3)
.
To remove LEVER HANDLES
(2)
; loosen SET SCREW
(7)
with Hex
Wrench provided with faucet. Pull LEVER HANDLE (2) off and
unthread HANDLE BASE
(3)
.
Thread HANDLE BASE
(3)
until snug against internal stop. Set VALVE
BODIES
(4)
so that their outlets are facing toward SPOUT TEE
(11)
and
then tighten LOCKNUT
(8)
using 35mm or adjustable wrench.
Insert WASHERS
(12)
into COUPLING NUTS
(13)
of SUPPLY HOSES
(14)
and tighten making water tight connection.
Important: Loop SUPPLY HOSES
(14)
as illustrated so they do not kink.
5, 17
6
1
3
2
15
16
8
4
12
HOT
13
14
9
11
10
7
Hex wench, supplied
JADO
MOUNTING
SURFACE
For Cross handles:
With VALVE in off position align CROSS HANDLE
(1)
as shown. Install CROSS HANDLE
(1)
onto VALVE STEM
(16)
and tighten HANDLE SCREW
(6)
. Insert HOT INDEX
(5)
into left CROSS HANDLE and COLD
INDEX
(17)
into right CROSS HANDLE.
For Lever Handles:
Install FRICTION WASHER
(15)
onto base of LEVER HANDLE
(2)
. With VALVE in off position align
LEVER HANDLE
(2)
as shown. Install LEVER HANDLE
(2)
onto VALVE STEM
(16)
and tighten SET SCREW
(7)
with HEX
WRENCH supplied.
Roman Tub Fillers
H 9 6 5 1 2 2 E
COLD
2
TEE AND HOSE ASSEMBLY
Press TEE
(1)
onto SPOUT SHANK
(2)
making certain that the
O-RING
(3)
is properly seated on SHANK
(2)
. Push COUPLING
(4)
into TEE
(1)
and attach to SPOUT SHANK
(2)
. Rotate TEE (1)
about 10 degrees from center, then tighten COUPLING
(4)
securely.
Insert WASHERS
(5)
into COUPLING NUTS
(6)
on SUPPLY HOSES
(7)
.
Tighten COUPLING NUTS
(6)
with wrench.
2
6
6
5
5
1
3
4
10˚
7
7
FRONT
11
