1
Turn off hot and cold water
supplies before beginning.
CAUTION
ROUGHING-IN
DIMENSIONS
1 0 9 6 4 3 A
1 0 9 6 4 3 A
INSTALL WALL SUPPLY
Plumbers' Putty or Caulking
Adjustable Wrench
Phillips Screwdriver
Channel Locks
TOOLS REQUIRED
Regular Screwdriver
(8" - 24") OPTIONAL
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
1/2" NPT
APPLY SEALANT
1
Supply to WALL SUPPLY (1) is 1/2" NPT. See rough-in above for detailed information.
Install RUBBER SEAL (2) onto WALL SUPPLY (1).
Apply sealant or teflon tape to threads of 1/2" NPT supply nipple. Thread WALL SUPPLY (1)
onto supply nipple making a water tight seal. WALL SUPPLY (1) with RUBBER SEAL (2)
should be tight against finished wall.
2
3
INSTALL HAND SHOWER HOLDER
INSTALL HOSE AND HAND SHOWER
1
8
10
9
2
Install SEAL (8) into COUPLING NUT (9). Connect COUPLING NUT (9) to WALL SUPPLY NIPPLE (10) and tighten.
INSTALL second SEAL (11) into SPRAY HOSE END (12 ) and connect HAND SHOWER (13) to SPRAY HOSE END (12).
Hand tighten.
Teflon Tape
5
3
FINISHED WALL
2
4
2
3
5
RECESS IN
MOUNTING
SUPPORT
11
12
13
7
4
5
The SHOWER HOLDER (1) works best if secured to a wall stud or cross brace within the wall, using the SCREW (2) supplied.
If the SHOWER HOLDER (1) is to be installed on a tile or plaster wall, the ANCHOR (3) and SCREW (2) should be used.
Install RUBBER WASHER (5) in recess of MOUNTING SUPPORT (4). Secure MOUNTING SUPPORT (4) to wall with SCREW (2).
For installations on drywall or tiled walls:
Use ANCHOR (3) and SCREW (2) for securing MOUNTING SUPPORT (4) to finished wall.
Drill a 1/4" dia. hole a minimum of 1-3/4" deep. Insert the the ANCHOR (3) flush with face of the finished wall.
Determine desired height and location (optional) and mark a center line. If MOUNTING SUPPORT (4) is secured to a stud or cross brace
drill small pilot hole for SCREW (2).
Install SHOWER HOLDER (1) onto installed MOUNTING SUPPORT (4). Push SHOWER HOLDER (1) flush against finished wall and
tighten SET SCREW (5) with (2.5mm) HEX WRENCH (7) supplied, to secure SHOWER HOLDER (1) to wall.
7-5/8"
1-1/8" D.
WALL SUPPLY
WITH BUILT IN
BACK FLOW
PREVENTER
(1/2)
1-1/16"
1/2
N.P.T.
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
RUBBER GASKET
FINISHED
WALL
1/2 NPSM HOSE
CONNECTION
3-3/4"
59"
