ROUGHING-IN
DIMENSIONS
1 0 9 6 5 1
1 0 9 6 5 1
Phillips Screwdriver
TOOLS REQUIRED
The wall mounted accessories work best if secured to a wall stud or cross brace within the wall, using the SCREW (1) supplied.
If the wall mounted accessories are to be installed on a tile or plaster wall the ANCHOR (3) and SCREW (1) should be used.
Secure MOUNTING POST (2) to wall with SCREWS (1).
Installation for two posted accessories are installed in the same maner but at the indicated dimension between the posts.
For installations on drywall or tiled walls:
Use ANCHOR (3) and SCREW (1) for securing MOUNTING POST (2) to finished wall.
Drill a 1/4" dia. hole a minimum of 1-3/4" deep. Insert the ANCHOR (3) flush with face of the finished wall.
Determine desired height and location (optional) and mark a center line. Using the MOUNTING POST (2) as a template mark the
spot for the ANCHOR (3). If MOUNTING POST (2) is secured to a stud or cross brace, drill small pilot hole for SCREW (1).
1
INSTALL WALL BRACKET
2
INSTALL ACCESSORY
Install WALL MOUNTED ACCESSORY onto installed MOUNTING POST (2). Push WALL MOUNTED ACCESSORY flush against
finished wall and tighten SET SCREW (4) with HEX WRENCH (5) suppied to secure to wall.
Robe Hook
TISSUE HOLDER
SOAP DISH
Soap Dish
ROBE HOOK
TUMBLER
Drill
Level
10'
Tape
Measure
Regular Screwdriver
2
3
3
1
1
4
4
4
2
2
3
1
OPTIONAL TO
FINISHED FLOOR
OPTIONAL TO
FINISHED FLOOR
1/4" DIA. HOLE
FINISHED
WALL
2-7/8"
5-1/2"
Tissue Holder
Tumbler
OPTIONAL TO
FINISHED FLOOR
OPTIONAL TO
FINISHED FLOOR
5
5
5
5 - 1 / 2 "
4 - 3 / 4 "
5 - 1 / 2 "
5 "
2 - 7 / 8 "
4 - 1 / 2 "
1 - 1 / 2 "
2 - 3 / 4 " D .
5 / 8 "
3 - 7 / 8 "
5 - 1 / 2 "
1 - 1 / 2 "
