Page
5.0 Power Requirements
Jacuzzi® spas are designed to provide optimum performance and flex-
ibility of use when connected to the maximum electrical service listed in
the tables below. If you prefer, your dealer can perform a minor circuit
board modification to allow your spa to accept an electrical service other
than the factory setting. The operational considerations of these modifi-
cations are listed in the footnotes below.
US / Canada J-325 1-Pump Models (60Hz)
240V/50A*
240V/40A**
Voltage:
240 VAC
240 VAC
# of Wires:
3
3
Frequency:
60Hz
60Hz
Current Draw:
36A
26A
Circuit Breaker:
50A, 2-Pole
40A, 2-Pole
* In the 50A configuration, the heater will operate at the same time as
the high-speed jets pump. This is the factory setting.
** In the 40A configuration, the heater will not operate at the same time
as the high-speed jets pump.
US / Canada J-315 1-Pump Convertible Models (60Hz)
120V/15A*
240V/30A*
240V/40A**
Voltage:
120 VAC
240 VAC
240 VAC
# of Wires:
3 (15A GFCI Cord,
4
4
US Only)
Frequency:
60Hz
60Hz
60Hz
Current Draw:
12A
21A
30A
Circuit Breaker:
15A, 1-Pole
30A, 2-Pole
40A, 2-Pole
For 240 VAC Heater Operation:
Move the red wire on the main terminal
strip (TB1) from position #1 to position #3. Make certain wires are con-
nected exactly as shown in Figure-D (page 13) before applying power.
Failure to do so will result in damage to the circuit board and/or related
components and void the manufacturer’s warranty.
*
In the 15A and 30A configuration, the heater
will not operate
at the
same time as the high-speed jets pump.
The factory setting is
120V/15A. Note: All Canadian spas must be hard wired (120 VAC
or 240 VAC) per CSA Canadian standards see page 4 for details.
**
If the spa is to be operated on 40A service, remove the jumper JP1
#1-2 on the circuit board to allow the heater to operate at the same
time as the high-speed jets pump (Page 3).
Summary of Contents for Premium J-315
Page 55: ......
