Jacuzzi lodge M, Use & Maintenance

Page: 22 / 60

22
ROUTINE MAINTENANCE
X
Keep the hot tub covered at all times when not in use. In this
way, along with keeping the water from getting dirty, you will
also avoid heat loss and evaporation.
X
Periodically clean the hydromassage and suction nozzles.
CAUTION
Never clean the hot tub with the pump running. Turn off
the main switch first.
CAUTION
After cleaning, immediately put the grilles of the aspi-
ration nozzles back in place. These safety devices must
cover the suction intake in order to reduce the risk of
hair or other body parts getting caught. The intakes
must be cleaned with the bath empty.
Remember to refit all the parts before re-filling the hot tub.
The suction intake grilles must be checked at least once
a week.
Maintenance of cartridge filters
The filters must be periodically cleaned, according to the amount
of use the hot tub is subject to, and replaced when necessary, when
they show signs of deterioration.
The cartridges are available from Jacuzzi® authorised dealers
and Service Centres.
X
Check the skimmer at least once a week to remove any sedi-
ment such as leaves, hair, etc.
X
Periodically check the filters; with normal use of the hot tub,
it is advisable to clean the filters at least once a week (clogged fil-
ters cannot keep the water clean; they also compromise proper
operation of the system).
CAUTION
Never clean the hot tub with the pump running. Turn off
the main switch first.
X
To clean the filter, remove the cover from the skimmer and
follow the steps indicated.
X
Separate the filter folds and clean with a jet of pressurised water.
If the filter is clogged, it is advisable to use specific products for
the removal of encrustation and grease, available from author-
ized Jacuzzi® dealers and service centres.
X
Refit, repeating the operations in reverse order.
CAUTION
After cleaning the filter, do not re-start the hot tub until
you have re-assembled all components.
Maintenance of thermal cover
Leatherette
X
Use a neutral cleaner, then rinse with clean water.
X
If necessary, use a specific product after cleaning to restore
and maintain the material’s shine.
SPECIAL MAINTENANCE
Winter inactivity
In areas where winter temperatures frequently drop below 0°C,
during periods in which the hot tub is not used, proceed as follows:
X
Turn off the power supply on the main panel.
X
Completely drain the hot tub via the drain valve, which is to
be left open, and the possible gate valve installed on the auxil-
iary drain (if installed; refer to the pre-installation instructions).