20
AL2
20
20
3 sec.
4 sec.
5 sec.
1 sec.
2 sec.
2
1
2
1
30°C
2
3
1
2
i
i
i
1
3
1
2
15 min
15 min
15 min
45 min
15 min
i
“Shiatsu”
It is possible to personalise
the function by excluding
one or two pairs of jets so that the
massage is concentrated in cer-
tain areas rather than others.
“Cervical/lumbar”
“Sequential”
Selects the type of massage.
Press to activate
(or stop).
It is possible to vary the jet pair activation speed.
Press the “<” key to decrease or the “>” key to
increase the speed.
TONIC
RELAX
CERVICAL
LUMBAR
It is possible to vary the jet pair activation speed.
Press the “<” key to decrease or the “>” key to
increase the speed.
Selects the type of massage.
Press to activate
(or stop).
Press to stop
(or reactivate).
(continuous jet)
The jet pairs are activated (represented
by 4 half-circles) from the bottom up-
ward in sequence. Each pair remains
active for 3 seconds.
When the keys are pressed, an arrow ap-
pears. Move the arrow to the pair which is
to be disabled.
Press to confirm
A c c e s s
is pro-
vided to the
"Turkish bath"
function.
If a few seconds
pass without
pressing any
key, the num-
ber under the
drops will flash.
Press the “on/
off” key to re-
turn to temper-
ature adjust-
ment.
It is possible to vary the selected value, even when the function has been
activated, by pressing the “on/off” key (the number flashes) and by using
the “<” or “>" key.
If you wish to carry out a Turkish bath using the preset values, do not press any keys.
40-45° C
(Preset value)
35-40° C
45-48° C
It is possible to set different
values where desired.
Press to confirm this value (a line
under the symbol will appear).
Turkish bath duration
(in minutes)
Press to confirm.
Where desired, it is possible to modify
the duration (minimum of 5 min-
utes, maximum of 45 minutes).
The steam will be released
from the nozzles (dispenser)
after a couple of minutes,
and hence, the Turkish bath
countdown duration com-
mences. The illuminated
sectors will turn on and off
in succession. Upon reach-
ing
30° C
the sectors all re-
main lit.
ATTENTION!The emerging steam
has a temperature close to 100°C!
Do not rest legs on the steam outlet,
keeping them at least 40 cm from the
steam nozzles.
Upon com-
pletion of the
function, an acous-
tic signal sounds
and the "waterfall"
key flashes. It is
possible to activate
a cold water jet,
which is released
from the roof open-
ing, when pressing
this key within a
few seconds. Do not
press this key if you
do not intend to use
this function, At this
stage, the steam
generator washing
cycle will begin;
during this time, it is
not possible to acti-
vate the hydraulic
functions up until
the point where the
"Turkish bath" key
stops flashing.
Temperature
Duration
Press to stop
(or reactivate).
