Control Panel & Cell Installation
Section 2 b
Control Panel
Using the supplied anchors and screws, the Control Panel should be mounted on a flat, sturdy,
vertical surface away from direct exposure to sunlight. The Control Panel is equipped with a 3.65 m
DC cell cord and flow detector cord. For ease of installation, please ensure that both cords connect
to the cell and flow detector while still providing slack in each cord for future service. Using a
torpedo level and permanent marker, hold and level the Control Panel on the surface to be mounted
and dot each of the (4) mounting holes. Using a .63 cm drill bit, drill to a depth of 2.5 cm and install
the supplied anchors. The Control Panel is now ready to receive the (4) mounting screws to secure
the installation.
DO NOT SHOOT OR PERMANENTLY ATTACH THE CONTROL PANEL TO THE WALL! This will void the
WARRANTY.
NOTE: Install at least 1.53m from the inside wall of the pool or spa.
CAUTION - YOU MUST REMOVE THE OUTPUT CONTROL DIAL BEFORE ATTEMPTING TO REMOVE
THE COVER. FIRST PRY OFF THE CAP AT THE TOP OF THE KNOB, WHICH WILL REVEAL THE HEX
NUT. LOOSEN THE NUT AND LIFT OFF THE KNOB.
Typical In-Line Equipment Power
Connection (220V)
NOTE 1 : FOR 24 HOUR OPERATION AS A "CONVECTION STYLE" INSTALLATION, SEE APPENDIX
(PAGE 18)
NOTE 2: IF YOU NEED A TIME CLOCK FOR CONTROL OF THIS UNIT AND YOUR 110 VOLT POOL
PUMP (PLUG IN), ASK ABOUT OUR PORTABLE TIME CLOCK .
8
POWER SUPPLY
COMMANDER I
Output Control
SINGLE GANG
JUNCTION
BOX (WIRENUT
CONNECTIONS)
Required
lt Leve
Sa
l
2500 - 3500
Flashing Green Light –
Generating Purifier
ght
Flashing Red Li
– Check System
FROM
POOL
PUMP
TO
POOL
HEATER
¶ ¶
¶ ¶
FLOW DECTECTOR CORD
FLOW DETECTOR
DC CELL CORD
CELL
CELL UNION (TYP.)
OPTIONAL 2 LB / 13.8 kPa CHECK VALVE (FOR HIGH
FLOW CONDITIONS OVER 50 GPM / 189 LPM).
F
I
L
T
E
R
LOADSIDE AC POWER
FROM EXTERNAL
FILTER PUMP
CONTROL SYSTEM
External
Filter
Pump
Control
System
