background image

10- ADJUSTING THE SHOULDER STRAP

    The tank is contoured for the operator comfort.
    The shoulder straps can be quickly adjusted to properly 

position the sprayer on the operator's back.

See below.

TIGHTENING

- Hold the strap buckle firmly with one hand, 

and pull the handle downward with the other 

hand.

Buckle

LOOSENING

- Hold the buckle firmly with one hand, and 

pull the strap upward with the other hand.

Handle

Buckle

04

13

11- ATTENTION

After assembling the sprayer, fill the tank with clean water and pressure-check the 

tank lid, diaphragm, tank base, lance and trigger valve for leakage. Most leaks can 

be stopped by retightening the appropriate connections and fittings. Any leakage 

must be repaired before returning the sprayer to service.

12- INVERTING THE LEVER OPERATING SIDE

This sprayer is assembled for installing the pumping lever for left hand operation. In case 

you wish to invert to right hand operation, proceed as follows:
- Remove the locking rings (1), washers and rod (2) from the chamber top.
- Turn the chamber top 180 degrees.

- Reinstall the rod (2) on the chamber top, fit the washers and secure the rod with the 

locking ring again.
- Remove the locking rings (4) and (5) and  washers.
- Remove the pumping lever (6).

- Take the container cap off and  carefully pour the rinse water into 
the spray tank.
- Continue holding  the container over the spray tank opening
for approximately 30 seconds to the last drop.
- REPEAT this operation twice more. This way, you complete the
TRIPLE WASH.

 

     

     - Next, make the plastic and metallic containers  
 

 

 

 

 

useless by piercing with a pointed instrument the  

 

 

 

 

 

containers bottom. This way, their labels are not  

 

 

 

 

 

damaged for identification purposes.

- The useless containers can be placed temporarily in an appropriate place, until final destina

-

tion. 
- In the case of mid and large size container (5, 25 and 50 gallon), after washing with the appropriate 

volume (1/4 of the total) and fitting the cap, roll it on the ground during approximately 30 seconds.

 - In the upright position complete the agitation by moving back and forth for approximately 30 
seconds. 
 - Empty the container by pouring the rinse water into the sprayer tank. 
 - REPEAT this operation twice more. Finally, totally empty the container by pouring rinse the  
water in the spray tank.
 - The least the amount of  rinse water that remains in the container, from one wash to the next, 
the better the decontamination will be.
 - For the performance of the TRIPLE WASH,  do not use a water  volume  either much lower or 
much higher than 1/4 of the container  capacity.

-The TRIPLE WASH must be done IMMEDIATELY AFTER emptying  the container, during the 
preparation of the solution

     

SOURCE - ANDEF (NATIONAL ASSOCIATION OF VEGETAL DEFENSE)

Summary of Contents for CD 400









Reviews: