3 SET UP
en-12
3.8
FRONT CASTER WHEELS __________________________________________________
Note:
Front caster wheels have been assembled to
the deck rotated 90° from correct position for
shipping.
1.
Start engine and lift deck off ground.
2.
Remove front caster wheels from deck. Remove all
four sets of hardware
(Y)
, not just the single set
holding caster in shipping position.
3.
Remove retaining pin
(V)
and spacers
(W and X)
above the caster support. Remove caster wheel, yoke,
and any remaining spacers
(X)
from bottom of support.
4.
Refer to the height of cut decal. Place correct number
of 1/2 in. (13 mm)
(X)
and 1/4 in. (6 mm)
(W)
spacers
on yoke shaft. Slide yoke into support. Place any
remaining spacers above support and insert retaining
pin
(V)
.
5.
Use four 7/16-14 x 3/4” screws and lockwashers
(Y)
to
assemble caster wheels to deck in correct position for
desired height of cut. Refer to height of cut decal.
Figure 3H
3.9
LEVEL DECK _____________________________________________________________
1.
Insert clevis pin
(Z)
through correct hole in rear brackets
for desired height of cut. Secure with hair pin
(AA)
.
2.
Lower deck to the ground. Check to see if deck is
level.
3.
If deck is not level, remove clevis pin
(Z)
from low side.
4.
Move one leveling spacer
(M - Figure 3E)
from bottom
of push arm to top of push arm on low side.
5.
Insert clevis pin and check if deck level again.
Figure 3I
3.10 DECK VALVE HOSE _______________________________________________________
1.
Remove plugs
(AB)
from deck valve. Deck valve is
located under floorboard in cutout in front axle.
2.
Connect hose
(O
1
)
from right (Pressure) side of deck
motor to M1 (Pressure) port of deck valve. Torque
hose to 50 ft. lb. (68 Nm).
3.
Connect hose
(O
2
)
from left (Return) side of deck
motor to M2 (Return) port of deck valve. Torque hose
to 50 ft. lb. (68 Nm).
4.
Remove plug
(AD)
and connect motor drain hose
(AC)
to 90° fitting on top of deck motor. Angle hose slightly
to the right. Torque hose to 17 ft. lb. (23 Nm)
5.
Tie wrap motor drain hose
(AC)
to deck pressure hose
(O
1
)
in two locations.
6.
Fully raise and lower the deck to be sure motor hoses
do not rub on deck or mower. Adjust hose positioning if
required.
7.
Store caps
(AB)
and plug
(AD)
in a safe location in
case deck needs to be removed from the tractor.
Figure 3J
X
Y
X
W
V
Z
Z
AA
AA
O
1
O
2
G
C
AC
AB
AD
Summary of Contents for Turfcaet Series
Page 21: ...NOTES 7 en 21 7 NOTES...
Page 23: ......
Page 43: ...MUISTIINPANOJA 7 fi 21 7 MUISTIINPANOJA...
Page 45: ......
