Jacobsen Bunton 630024, Setup, Parts & Maintenance

Page: 5 / 41

3
Gear
Drive
Midsize
GENERAL NOTE: FRONT, REAR, RIGHT HAND AND LEFT HAND REFERENCES BELOW
ARE WITH RESPECT TO AN OPERATOR AT THE CONTROLS.
ASSEMBLY/SET-UP INSTRUCTIONS
2. Remove gear selector handle A from the power
unit and set aside for later use.
3. Remove P-Clip C from crate and upper handle
B.
4. Remove parts bag D from lower handle B and
set aside for later use.
5. Remove traction rod E from shipping bracket F
on both sides of the power unit and set aside for
later use.
6. Support power unit, using jack stands as shown.
7. Remove upper handle B from shipping bracket
F.
NOTE: Retain hardware from Step 7 for later use
and discard shipping brackets.
1. UNCRATE - Place both power unit and cutterdeck crates on a level surface. Remove sides and top
from both the power unit and cutterdeck crates.
8. Attach upper handle B to the lower handle using
the 3/8”-16X1 bolts and 3/8”-16 nuts removed in
Step 7 as shown.