5 OPERATION
16
5.9 MOWING_________________________________________________________________
To mow:
1.
Start the engine and lower the mowers to the ground.
2.
Turn PTO switch to ON, depress front of desired
mower switch(es), shift tractor to 4WD and
disengage parking brake.
3.
Move throttle lever to FAST then slowly depress
traction pedal to the desired mowing speed.
a.
For complete even cutting, overlap swaths by a
few inches.
b.
When cutting tall grass, cut grass higher than
desired the first time so mower will clear unseen
obstructions and will not scalp if ground is rough.
c.
Stop and raise the mowers to the transport
position when crossing paths or roadways. Look
out for traffic.
4.
For better traction and handling, adjust ground
pressure and engage differential lock.
5.
When operating in reverse and additional power is
required to climb out of a small depression, press
and hold the 2WD/4WD in the momentary 4WD
Reverse position.
5.10 TOWING / TRAILERING_____________________________________________________
If the tractor experiences problems and must be shut
down and removed from the area, it should be loaded
onto a trailer for transport. If a trailer is not available, the
unit can be towed slowly short distances.
NOTE:
Do not exceed 2 MPH (3.2 KPH) while towing.
Long distance towing is not recommended.
Use care when loading and unloading tractor. Fasten
tractor to trailer to prevent tractor from rolling or shifting
during transport.
Before towing, open tow valve. The tow valve permits
moving the tractor without starting the engine and
prevents possible damage to hydraulic components.
The tow valve (
Z
) is located on the drive pump beneath
the seat. Pull seat tilt knob and rotate seat forward.To
open valve, insert a pin into the small hole in the tow
valve and turn the valve counterclockwise 90°.
Close valve completely and make certain seat is latched
in the closed position.
Figure 5B
WARNING
To prevent serious injuries, keep hands, feet and
clothing away from cutting unit when the blades are
moving.
NEVER
use your hands to clean cutting units. Use a
brush to remove grass clippings from blades. Blades
can be sharp and could cause injuries.
To clear obstructions from cutting unit, disengage PTO
switch, engage parking brake, stop engine and
remove key from ignition switch then remove
obstruction.
!
WARNING
With the differential lock engaged, the effort required to turn
the tractor is increased and the tractor’s steering ability is
reduced. Stop machine and disengage differential lock
before turning.
To prevent tipping or loss of control, travel at reduced speed
when making turns.
!
Normal
Operation
Tow
Position
Summary of Contents for 69158
Page 18: ...6 NOTES 18 6 NOTES ...
Page 19: ......
