8 MAINTENANCE AND LUBRICATION
en-68
Keep tires inflated at the correct pressure (
)
8.15 WHEEL MOUNTING PROCEDURE____________________________________________
Remove dirt, grease and oil from the stud threads. Do not lubricate threads.
Put the wheel on the hub. Inspect the wheel to make sure of full contact between surface of
wheel and hub.
Tighten all hardware with your fingers, then torque hardware in the order shown. When
possible, tighten nuts in the top position.
Check and torque hardware each day until torque is kept at 85-95 ft.lb. (115-128Nm).
8.16 ROPS ___________________________________________________________________
A Roll Over Protective Structure (ROPS) is included with this mower. Inspect the ROPS weekly for loose hardware or
damage.
Inspect the seat, seat belt, ROPS mounting hardware and ROPS frame for damage in accordance with maintenance
chart. Replace all damaged parts immediately. All replacement parts for the ROPS must be as specified in the Parts
Manual.
Check and torque all ROPS hardware in accordance with maintenance chart.
CAUTION
DO NOT try to put a tire on a rim unless you have the correct training, tools and experience. Incorrect mounting can
cause an explosion which can cause injury.
WARNING
Make sure the mower is parked on a solid and level surface. Never work on a mower that is supported only by the
jack. Always use jack stands.
If only the front or rear of the mower is lifted, put the chocks in front of and behind the wheels that are not lifted.
CAUTION
Keep the ROPS hardware correctly tightened. Do not do any welding operations, drill, change or bend the ROPS.
Replace a damaged ROPS. Do not try to correct a damaged ROPS.
DANGER
In off road or transport mode, the seat belt must always be worn. The ROPS frame must be in the position for
operation. This instruction is given to meet:
The machinery directive, 2006/42/EC Sections 3.2.2, Seating & 3.4.3, Rollover.
Jacobsen recommends that the owner/operator of the machine complete a local risk assessment on the machine to
find any conditions that do not follow this rule.
!
!
1
2
3
4
5
!
!
Summary of Contents for 672256G01
Page 96: ......
Page 97: ...SPECIFICATIONS 12 en 95...
