jaclo
industries
| 129 Dermody Street Cranford, NJ 07016
p
908.653.4433 | 800.852.3906
f
908.653.1717 | 800.852.4133
CREATED 2.24.15
JACLO.COM
| PG 6
INSTALLATION
A1. A2.
For ideal installation, lower part of showerhead must be placed at a height of about 78-3/4” from the floor.
The recommended flow rate for good functioning of the showerhead is 4 gallons per minute.
B.
Place the support (1) against the wall and make sure the supply adapter (2) is lined up with the central hole of
the support.
C.
Temporarily fix the support (1) by screwing the supply adapter (2) into the appropriate outlet.
D.
Make sure the support is perfectly horizontal to the floor by using a level. Use a pencil to mark the
slots corresponding to the six holes for inserting the anchor screws (3). Unscrew the supply adapter (2) and
remove the wall support (1).
E.
Drill the six holes using an 8 mm drill bit.
F.
Fasten the support (1) by screwing the supply adapter (2) and the six screws into the wall (3).
G.
Insert the showerhead (4) and screw the fastening dowels (5) already mounted onto the support.
H.
Fix the free end of the gas springs (9) onto the lower part of the support with the suitable screws (6).
I.
Apply the cover (7) until it adheres completely to the wall.
L.
Fasten the cover to the plate with the suitable screws (8).
M.
Remove the protection film (10) from the showerhead (4).
RECOMMENDATIONS FOR PROPER USE
PROPER USE OF THIS PRODUCT WILL ALLOW YOU TO AVOID DAMAGES TO THE BATHROOM ENVIRONMENT.
*
To prevent impurities or debris from getting inside the product and causing functional problems, always
flush out the system before connecting it to the supply pipes. It is recommended to install the filter at the
system’s water intake.
*
To keep the diffuser clean and prevent lime scales from clogging the diffuser, we advise that you periodically
rub the silicone nozzles to free them of the lime deposits.
