08
Warning
：
Do not remove the battery pack without permission,If you need to repair the battery pack,
contact your local manufacturer as soon as possible
DANGER:
This device is intended to be used indoors only. Do not use outdoors under any conditions.
1.Press the AC button, AC output will be turn on; and press the button again, the AC output will turn
off
，
while the AC LED will turn off within 1~2seconds.
2.Press the any 1or 2 way DC(USB or 12V) button, output will be turn on; and press the button again,
the DC output will turn off
，
while the DC LED will turn off within 1~2seconds.
3. If DC or AC output is on LCD will display “OUPUT” icon and output power unless all DC output is off
• DO NOT use the unit in an area or environment with high temperature.
• Should fluid from inside of the unit come in contact with your skin or clothing, wash the affected
areas with tap water.
• In a storm, unplug the power cord from the socket.
• DO NOT place the unit on its side or upside down while in use or storage.
• DO NOT use accessories for other usage.
• Make sure that the device you are connecting is switched off before you connect it.
• DO NOT expose a power pack to fire or excessive temperature. Exposure to fire or temperature
above 130°C may cause explosion.
• Solar charge times depend on weather conditions, place your solar panel where it will get as much
direct sunlight as possible.
• DO NOT place the power pack on the floor, or at a height less than 457 mm (18 inches) above the
floor, during use in a repair facility.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Charging instruction
• DO NOT move the unit if it is recharging or in use.
• DO NOT dispose the unit together with household waste.
• DO NOT place the unit close to or in a fire or expose it to heat. Keep out of direct sunlight.
• DO NOT store the unit in a bathroom or in an area exposed to rain or moisture.
• DO NOT disassemble the power pack, take it to a qualified service person when service or repair is
required. Incorrect reassembly may result in a risk of fire or electric shock.
• DO NOT store the unit in an area or environment with high temperature.
MOVING AND STORAGE INSTRUCTIONS
Before using or storing, plug your Jackery Explorer into the wall until it is fully charged. If you see the
LCD battery is low at any point, plug it into a power source, like an AC outlet or a solar panel as soon
as possible.
USER MAINTENANCE INSTRUCTIONS
Discharging instruction
1.The product supports any 1 way or 2 way charging .
2.Charge the Portable Power Station with charger; the LCD will turn on and display Input power
3.Display will show 100% capacity when fully charged .
US
