
图 5-8(Figure 5-8)
7、滤油器的检查和更换(oil filter inspection and replacement)
过滤器有灰尘在上面,不能正常使用,每使用 6 个月后请进行检查或更换。
注:如果油按规定的油量加入,油窗喷出的油量异常、过弱、有气泡等现象时,请
及时更换或清扫过滤器(Oil filter, can't work smoothly with dust on it. Please
check or replace every 6 months.
Note: If the add the oil according to the provisions, but in the oil window
the oil shows abnormally, too weak, with bubbles, please promptly replace
or clean the oil filter.)
图 5-9( Figure 5-9)
注意:为了防止机器突然启动造成人身事故,请关掉电源,确认电机确实停止转动
后再进行操作!(Warning: In order to avoid any accident, before operating
please make sure power is off and motor is stopped.)
)
Summary of Contents for W4 Series
