8
9
ASSEMBLY (Cont.)
STEP 5:
Place Pulp Collector on the right side
opposite the Locking Bar. Collector will
fit under the lip of the Receptacle.
Place Lid/Pulp Guard on top of
Receptacle, making certain it is snugly
aligned with the protruding Guard
facing in the opposite direction of the
Juice Spout. The Guard should fit over
the Pulp Collector. Lock Lid into place
by lifting Locking Bar up until it clicks
into grooves located on both sides of the Lid/Pulp Guard.
Make sure Locking Bar is in the full upright, locked position.
IMPORTANT: The unit will not start
until this Locking Bar is properly
locked into place.
5
Receptacle
Locking
Bar
Pulp
Collector
Lid/Pulp
Guard
STEP 4:
Place Blade inside Filter, sharp
side up and centered over Screw
Peg. Using the Crescent Tool,
insert metal pegs into matching
holes in Blade. While holding
filter in place, turn Crescent Tool
clockwise to tighten Blade in
position.
IMPORTANT: Do not over
tighten as the Screw Peg
will break. Remove Crescent
Tool and set aside.
Blade
4
Hold
Filter
Crescent
Tool
Blade Holes
CAUTION: Do not leave tool inside juicer.
NOTE:
The bottom of the Crescent tool
is magnetized. It can be attached to the
metal Locking bar for easy convenience.
Crescent Tool
