Lip
Pulp Guard
Chute
Locking Bar
5
4
HELPFUL HINTS
Obtain the best results from your Jack LaLanne Power Juicer
by following these helpful hints.
• Do not put any fruit or vegetables in your machine until power is turned on.
• Allow unit to run for at least 10 seconds before juicing.
• Do not force food into the juicer. Allow food to pass through slowly and steadily using
the pusher. You do not need to apply pressure unless the juicer starts to vibrate. Then
only a slightly harder push should bring it back to balance.
• Any fruit or vegetable that will fit the chute can be put through whole. The only time it is
necessary to cut is when something is too large. Then it should be cut into large enough
pieces to fit in the chute. Do not cut pieces too small.
• Remove large pits such as peach, mango, etc. as they will damage the blade and possibly
the unit. Before juicing cherries we recommend you remove the pits using a cherry pitter.
• Cleaning can be made easy by placing a plastic bag inside the pulp collector container.
When you are done juicing, the bag can be lifted out and disposed of easily leaving the
pulp collector easier to clean.
• Let the Power Juicer run for a few minutes before turning off to allow any excess juice to
be extracted from the pulp. Once turned off it is quite normal for the juicer to spin for a
minute or so due to the very fine precision balancing of this appliance. Wait until it is
done spinning before disassembling.
• Do not use bananas or avocados as they do not contain juice and will clog machine. Add
them separately in a blender.
• We do not recommend using overripe fruit as it will leave too much pulp in the filter and
clog the machine.
• Do not pour liquids into the machine at any time.
Pusher
Filter
Blade
Crescent Tool
(for tightening and removing blade)
MAIN UNIT
(Fully Assembled)
Receptacle
Juice Spout
Screw Peg
Base
Pulp
Collector
PARTS LIST
(Crescent tool pegs fit here to tighten.
WARNING: DO NOT OVER TIGHTEN)
(Pegs fit into blade.)
Lid with Built-in Pulp Guard
SAVE THESE INSTRUCTIONS
ADDITIONAL SAFEGUARDS
The Power Juicer has a thermal cut-off safety feature. If the unit accidentally overheats, it will
stop working temporarily until the Power Juicer cools down. Afterwards, the unit will continue to
work again normally.
In the event the Power Juicer is jammed the motor may shut down. If this occurs the juicer should
be shut off and unplugged. The unit should be thoroughly cleaned to remove the obstruction.
The thermal cut-off safety feature is designed to shut off the motor when it over heats.
Please use extreme caution when handling the Power Juicer blade as the blades are very sharp.
Always turn power off to the Power Juicer immediately and remove power cord from electrical
outlet before disassembling to clean due to any food obstruction.
CAUTION
Use caution when handling blade as blades are very sharp.
If juicer jams turn power off immediately and remove power cord from electrical outlet before
disassembling to clean.
The Power Juicer has a thermal cut-off safety feature. If the unit accidentally overheats, it will stop
working temporarily until the Power Juicer cools down. Clear any obstruction. Afterwards, the unit
will continue to work again normally.
Summary of Contents for Power Juicer
Page 1: ...OPERATING MANUAL...