ZonePod
Quick Installation Guide
2
www.jacarta.co.uk
The ZonePod will automatically detect the type of sensor installed and load the appropriate default
settings, when the sensor is connected.
iii.
Attach the power supply to your power circuit / socket and connect it to the Zonepod.
Switch the power on.
The Zonepod will start up with the following screen.
iv.
The screen will then change to automatically show the attached sensors. This is the “sensor
status” screen.
The diagram above shows a temperature sensor in port 1. The top row
shows ports 1 to 3 from left to right. The bottom row shows ports 4 to 6
from left to right. To get into and navigate around the menus you use the
keypad located to the right of the LCD screen. To access the main menu,
press down the middle button ‘OK’ until it appears.
3. The Zonepod configuration
Below is shown how the six sensor ports trigger the four voice / text messages on the Zonepod
speech dialler.
Standard Zonepod
If you require the current port status for one of the Zonepod sensor ports this can be shown on the
main screen (see the full user manual) or indicated via the LEDs on the front panel of the unit.
JACARTA ZONEPOD
LOADING...
TEMP
EMPTY EMPTY
EMPTY
EMPTY
EMPTY
Sensor Normal
(No Alarm)
Sensor Alarm
Low alarm
(temp and
humidity
sensors only)
No sensor
present
