wiJAC-Pxx Wireless Stand Alone Intercom System
Operating
Manual
Page 6
4.2
Purging
A JA65 that has already been paired with four JA64 headset adapters must be
purged to clear any existing pairings if it is necessary to replace one or more of
the headset adapters.
Note:
This process clears ALL previously paired units from the JA65. All
JA64 units
required for use in the system
must then be paired
with the JA65
.
The purging process is described in the following steps:
1. Turn off the JA65 and any other JA64 previously paired with the JA65.
2. Turn on the JA65.
The JA65 enters the standby mode (Power Annunciator blinks in sets of
two or three flashes). If the Power Annunciator stays on continuously,
there is a JA64 still powered on and is connected to the JA65. Please turn
off the JA64.
3. On the JA65, press and hold the Pair Switch (>8 seconds) until the
Power and Low Battery Annunciators turn off. Release the Pair switch.
The JA65 enters the purge mode (Power Annunciator blinks in sets of
three flashes). Wait for the JA65 to finish purging all paired JA65 from its
memory (approximately 10 seconds).
4. Turn off the JA65.
5. Turn on the JA65. If the Power Annunciator blinks in sets of three
flashes, the purging process was successful. If the Power Annunciator
blinks in sets of two flashes, repeat the purging process from step 1.
CAUTION
:
To
minimize the risk of system malfunction, a JA64 must
not be paired with more than one JA65 at a time.
