JA95-060 Audio Controller - Five Transceiver - Expander
Installation and Operating Manual
Rev A
Page 12
3.3
Front Panel Controls
Note
: The legends and deadfront annunciator are removable and may be replaced with custom ordered
parts. The controls will be referred to by the default legend and annunciator names as shown below.
1. Transceiver switches and associated legends
2. Music/configuration input connector and legend
3. Transmit annunciator (deadfront)
4. Transmit selector
5. AUX Legend
(1)
Transceiver Switches
These are five white two-position toggle
switches. When a switch is set to the ‘up’
position, audio from the associated
transceiver is routed to the phones.
The legends (above the switches) are
interchangeable to allow customization.
(Default – AUX1, AUX2, AUX3, AUX4, AUX5.)
(2)
Configuration Connector (io)
This connector is used during installation to change configuration settings.
CAUTION
:
Attempting to connect an incompatible plug or device could damage the unit, the attached
device, or both. If in doubt, check with your installing agency.