to match wire colors. Note: Install switch with yellow
wire on top for correct di rec tional aiming.
2.
To remove On/Off fuse switch disconnect wires to
defective switch and pull forward will gentle rocking
motion from back side of panel easing switch out.
Install new switch and secure using clip retainer on
back side of control panel. Reconnect wiring
terminals to switch.
BULB REPLACEMENT
Remove four (4) screws and re tain ing bezel. Pull bulb
assembly forward and disconnect spade connectors from
back of bulb. Reconnect spade terminals to new bulb.
Install bulb and fasten with bezel and four (4) screws.
PARTS LIST
Part
Description
Number
Bulb Kit
18753-0178
Directional Switch
43990-0000
On/Off Fuse Switch
18753-0180
Station Selector Switch
64073-0020
Control
60030-0000
12/24 Volt Converter
45969-1000
Upper Housing
60023-1000
Lower Housing
60024-1000
Base
60027-1000
Bulb Retainer
60035-1000
Motor-Vertical (upper)
18753-0458
Motor-Horizontal (lower)
18753-0350
CONTROL UNIT OPERATION
SWITCH FUNCTIONS
(A) Light Switch – On/Off switch positions.
(B) Directional Switch – Lever has eight contact
positions and will operate in horizontal, vertical, and
in four intermediate directions.
CLEANING OF EXTERIOR PLASTIC
SURFACES
Recommendation for cleaning “Exterior Sur fac es” is a
solution of warm water and a mild “dish washing”
detergent soap.
CAUTION
Do not use cleaners that contain esters,
halogenated sol vents, aromatic solvents, ketones and
strong acids or bases.
CIRCUIT PROTECTION
A 10 amp fuse is located in the On/Off toggle on control.
To replace fuse grasp On/Off toggle and push in while
turning to left facing control. Pull out fuse and replace.
The proper fuse has been included in the fuse holder.
Should this fuse blow, replace with the same size fuse
after determining reason for blown fuse.
NOTE: ON SOME MODELS THE FUSE HOLDER MAY
BE LOCATED SEPARATELY.
When installation and wiring is completed, check light
op era tion. If light is inoperative, or does not operate
correctly, refer to troubleshooting instruction.
SERVICE
CONTROL REPLACEMENT
Individual replacement parts are available for the control
panel. To replace switches remove the two (2) screws
from front of panel and pull forward, exposing wiring.
1.
To remove directional switch push firmly on the front
toggle and remove switch from back side of panel.
Cut wires to the defective switch, and splice wires
(with butt connectors) to the new switch, being sure
