Model 37202-Series
Model 37202-Series
ELECTRIC BILGE PUMPS
FEATURES
●
Pumpgard Inlet Strainer Supplied With Pump
●
Self-Priming
●
Diaphragm Design Allows Dry Running
●
Built-in Hydraulic Pulsation Dampener
●
Corrosion Resistant Materials Throughout
for Sea Water Service
●
Meets USCG Electrical Regulation 183.410
and ISO 8846 Marine for Ignition Protection.
●
N.M.M.A. Type Accepted
SPECIFICATIONS
Open Flow:
4.5 GPM
Vert. Dry Suction Lift:
7 feet
Ports:
3/4
" Slip-on Hose
Weight:
5.5 lb (2,5 kg)
INSTALLATION
MOUNTING
Mount upright in a dry location (above highest bilge water
level) on a solid surface. Mounting screws should be
tightened only enough to slightly compress grommets.
Overtightened screws will reduce cushioning effect of
mounts and may cause excessive noise.
PLUMBING
For intake and discharge, use 3/4" ID non-collapsible
hose. Keep intake and discharge lines free of kinks and
restrictions. To protect pump from debris, install the 3/4"
in-line strainer (Model 36200-0000) in the intake line
from the bilge. Use a 3/4" thru-hull fitting for discharge
located well above the waterline at all angles of heel.
WIRING
Wire pump in a circuit independent of all other electrical
fixtures. Use stranded copper wire. Install fuse in
positive circuit. See table for recommended wire and fuse
size. See diagram for wiring connections. Use a
10 amp-rated switch (3-way switch Model 44960-0001).
After installation, it is recommended that voltage be
checked at the motor terminals with motor operating
under full load. Be sure measured voltage is not less than
11 volts on a 12 volt system with a fully charged battery
.
STANDARD MODELS
Nominal
Fuse
Model
Voltage
Current
Size
37202-0000
12 Vdc
7.5 AMP
10 AMP
37202-0010
24 Vdc
6.5 AMP
10 AMP
MAINTENANCE
LUBRICATION:
Check connecting rod bearing annually
and add chassis lube as needed. No other lubrication of the
pump is required.
WINTER STORAGE:
The pump must be completely
drained, hoses removed and pump run until all water is
expelled.
WIRING TABLE
Wire Length Between
Battery and Motor
Wire Gauge
1 - 25 feet
12 AWG
25 - 50 feet
10 AWG
BATTERY
FUSE
MANUAL
OFF
AUTOMATIC
PUMP
3-WAY SWITCH
44960-0001
Automatic Bilge Switch
Model 34875-Series or
Any JABSCO Float Switch
WIRING DIAGRAM FOR AUTOMATIC OPERATION
-
+
DIMENSIONAL DRAWING
