U.S.A.
Jabsco
1485 Dale Way, P.O.Box 2158
Costa Mesa, CA 92628-2158
Tel: (714) 545-8251
Fax: (714) 957-0609
UNITED KINGDOM
Jabsco
Bingley Road, Hoddesdon
Hertfordshire EN11 OBU
Tel: +44 (0) 1992 450145
Fax: +44 (0) 1992 467132
CANADA
Fluid Products Canada
55 Royal Road
Guelph, Ontario N1H 1T1
Tel: (519) 821 -1900
Fax: (519) 821-2569
JAPAN
NHK Jabsco Company Ltd.
3-21-10, Shin-Yokohama
Kohoku-Ku, Yokohama, 222
Tel: 045-4758906
Fax: 045-475-8908
GERMANY
Jabsco GmbH
Oststrasse 28
22844 Norderstedt
Tel: +49-40-53 53 73 -0
Fax: +49-40-53 53 73 -11
© Copyright 2000, ITT Industries
Printed in U.S.A.
All Rights Reserved
Form: 43000-0613
Rev. 8/2000
THE PRODUCTS DESCRIBED HEREIN ARE SUBJECT TO
THE JABSCO ONE YEAR LIMITED WARRANTY, WHICH
IS AVAILABLE FOR YOUR INSPECTION UPON REQUEST.
MOUNTING
BRACKET
VENT TO
ATMOSPHERE
ELECTRICAL
CONNECTIONS
TO VENTED
LOOP
TO
NEGATIVE
TO
POSITIVE
TO
NEGATIVE
PUSH BUTTON
SWITCH
VENTED
LOOP
VIEW A
DISCHARGE TO
HOLDING TANK
INLET
WATER
LINE
VIEW A
DIAGRAM 1
DIMENSIONAL DRAWING
Inches (Millimeters)
MOTOR COVER
REASSEMBLY INSTRUCTIONS
Press seal into body with lip facing impeller; be careful
not to cock seal in bore. Install pump body on motor and
position on register; lubricate impeller bore with pump
grease. Install impeller, gasket and wearplate. Make sure
gasket surfaces are clean and smooth. Tighten
wearplate screws. Slide shaft sealing sleeve onto shaft
and seat in its bore in wearplate. Relocate centrifugal
impeller about 1/8” from wearplate and secure with set
screw. Position macerator housing around centrifugal
impeller then put chopper plate on end of shaft and
secure with lock nut. Install O-ring in O-ring groove in
wearplate surface (a little grease will help hold in place).
Aligning key on top of macerator housing with slot in
base, slide macerator assembly into base. Secure pump
assembly with the four screws.
