1 Litre Accumulator Tank
To replace the air cushion:
1. Turn off the power to the water pump.
2. Open the tap farthest from the accumulator tank.
3. Remove the plug in the top of the accumulator tank.
4. Open the drain cock, if fitted, or loosen the pipe
joint on the pump delivery side, to drain the water
system.
NOTICE
• Hand tighten only. Do not overtighten top plug or ‘T’
fitting as this will damage the tank.
• Plastic or similar fittings only are recommended.
• Do not paint the accumulator tank as this may lead
to deterioration of the plastic material.
Warranty: All products of the company are sold and all services of the company are offered subject to the company’s warranty and terms and conditions of sale, copies of which will be furnished upon request.
The information provided herein is for guidance only, it does not constitute a guarantee of the performance or specification of any individual product or component.
©Copyright 2000 ITT Industries
Discover Jabsco at www.jabsco.com
43001-0513 Rev: 03/03
Jabsco
ITT Industries
Jabsco,
20 Icon, Foothill Ranch, CA 92610
Tel : + 1 949 609 5106
Fax : +1 949 859 1254
Jabsco
,
Bingley Road, Hoddesdon, Hertfordshire, EN11 0BU
Tel : +44 (0) 1992 450 145
Fax : +44 (0) 1992 467 132
Fluid Products Canada
,
55 Royal Road, Guelph, Ontario N1H 1T1
Tel : +1 519 821 1900
Fax : +1 519 821 5316
NHK Jabsco Co Ltd
,
3-21-10, Shin - Yokohama, Kohoku-ku, Yokohama 222
Tel : +81 (0) 45 475 8906
Fax : +81 (0) 45 475 8908
Jabsco GmbH
,
Oststraße 28, 22844 Norderstedt
Tel : +49 (0) 40 53 53 73 0
Fax : +49 (0) 40 53 53 73 11
USA
UK
CANADA
JAPAN
GERMANY
Do not overpressurise the tank. Pressures
over 125psi (8.5 bar) may rupture tank and
cause personal injury.
Maintenance
Over time, the air cushion will be absorbed. This is
apparent when the pump starts to cycle rapidly if only
a small amount of water is used, for example by a
leaking tap, or when an instantaneous gas heater is
being operated on maximum heat setting.
5. Replace plug and washer in top of the accumulator
tank.
6. Close the drain cock, if fitted, or re-connect the
pipe joint, and leaving the tap furthest from the tank
open, switch on the pump. When water is flowing
smoothly, close the tap. The system should then
shut off automatically.
Dimensional Drawing
