4
english
Jabra CLIPPEr
GettInG stARteD
Follow these three steps before using your headset:
1 Charge your headset (approximately 2 hours)
2 Activate
Bluetooth®
on your mobile phone (refer to the
manual for your mobile phone)
3 Pair your headset to your mobile phone
CHARGInG YoUR JABRA CLIPPeR
Make sure that your Jabra CLIPPEr is fully charged before you start
using it for the first time . While charging, the battery indicator
changes from red to green, when fully charged . Charging time is
approximately 2h . You can use the Jabra CLIPPEr during charging .
Please note: The lifetime of the battery will be significantly
reduced if your device is left uncharged for a long period . Jabra
therefore recommends that you recharge your device at least
once a month .
tURnInG YoUR JABRA CLIPPeR on AnD oFF
- Press and hold the Multi-Function button until the LED turns
green to turn it on .
- Press and hold the Multi-Function button until the LED turns
red to turn it off .
- The headset will automatically turn off after 10 minutes if not
connected to a device .
PAIRInG YoUR JABRA CLIPPeR to A PHone oR
otHeR DeVICe
Headsets are connected to phones or other
Bluetooth®
devices
using a procedure called ‘pairing’ . by following a few simple steps,
pairing can be done in a matter of seconds .
1. Put the headset in pairing mode
1.a. First time pairing
- Turn on the headset and the Jabra CLIPPEr will automatically
enter pairing mode (indicator light is solid blue) and start
searching for a device .
