DIP Switch 1 Selection - Immunity to false alarms.
The NORM (OFF) down position combines very good immunity
with fast sensor reactions.
The HIGH (ON) up position gives increased immunity with a slower
reaction time and is only used for problematic installations.
DIP Switch 2
Leave in ‘ON’
up position
We recommend using a high quality brand name battery (e.g. Duracell, Panasonic). After the batteries have been replaced, detector function
should be tested.
After battery replacement, the detector needs about 3 minutes to stabilise during which its LED lights continuously. After the LED has stopped
indicating, test the detector’s functioning.
If a partly discharged battery is inserted then the LED starts flashing for one minute. The LED will stop flasing when a brand new battery is installed.
Expired batteries should be disposed of according to local regulations.
Battery
Type:
1
x
CR123A
Lithium
Voltage:
3.0V
DC
Typical battery life:
Approx. 3 years (5 min. sleep mode)
Communication
band:
868
MHz
Communication range:
Approx. 300M (open area)
Recommended installation height:
2.0 to 2.5 M above floor level
Detection angle/detection range:
120° / 12 M (basic lens)
Operational environment according to EN 50131-1
II.indoor general
Operational temperature range:
-10 to +40 °C
Dimensions:
85 x 60 x 55 mm
EN 50131-1, CLC/TS 50131-2-2, EN 50131-5-3 classification:
Grade 2
Complies with:
ETSI EN 300220, EN 50130-4, EN 55022, EN 60950-1
Can be operated according to:
ERC REC 70-03
15 minutes after closing the detector cover, the indicator shows
detector activation.
5 minutes / 1 minute sleep time
To save battery energy, the detector switches the battery to battery-
save mode 15 minutes after its cover is closed. During battery-save
mode the detector will still detect movement. The first movement
detected is then signalled to the receiver, and for the next 5 minutes
the detector ignores any further movement. After the 5 minutes
the detector then returns to watching out for movement until re-
triggered. The sleep time can be shortened to 1 minute by pressing
the tamper switch during battery installation and programming. Not
pressing the tamper switch gives a sleep time of 5 minutes.
Note: When adding the time element ‘Step 3’ of programming,
the recommended time is >5 minutes if the sleep mode is
set to 5 minutes, or >1 minute is the sleep mode is set to 1
minute. This ensure the PIR is active at all times.
The default lens supplied covers an angle of 120° and a distance
of 12 metres. The area is covered by three beams as shown in the
following pictures.
DIP Switches
Testing the Detector
Battery Replacement
Detection Characteristics
Technical Specifications
Scolmore Park, Landsberg, Lichfield Road Industrial Estate, Tamworth, Staffordshire B79 7XB
Tel: +44 (0) 1827 63454 Fax: +44 (0) 1827 63362
www.scolmore.com
V1.0
