![background image](http://html2.mh-extra.com/html/jabiru/j160/j160_technical-manual_3118859224.webp)
Aircraft Technical Manual
Jabiru Aircraft
Pty Ltd
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
Dated: 29th October 2014
Issued By: AS
Page: 224 of 298
8.2.4 Installation
Required Tools:
Screwdrivers
Parts and Material:
Fuel line springs, clips, Zip ties (if required)
Type of Maintenance:
Line Maintenance
Level of Certification:
L2 or LAME (A&P or LSA Repairman / Maintenance)
Return to Service:
L2 or LAME (A&P or LSA Repairman / Maintenance)
Care must be taken when re-routing lines to avoid bending the hose around too sharp a corner
– the
flexible hose used can crimp itself off if bent too sharply. If a sharp bend is unavoidable a spring may
be threaded over the line to prevent it crimping. Springs must be a snug fit on the hose & are
available from Jabiru Aircraft if required. Figure 169 refers.
Note that in some cases it may be necessary to shorten or lengthen lines
to prevent “U’s” or tight
bends.
For installation, reverse removal procedure given above.
Figure 169
– Sample Fuel Line Details (all J-Series)
Figure 170
– Fuel Lines Showing Typical “U” Requiring Correction (all J-Series)
Lines dip slightly as they
exit the header tank and
pass through the side of
the baggage shelf.
Fuel line clips
Line crimped
– bend too tight
Spring preventing line from
crimping on a tight bend