![background image](http://html1.mh-extra.com/html/jabiru/j120/j120_technical-manual_3130523149.webp)
Aircraft Service Manual
Jabiru Aircraft
Pty Ltd
JTM001-1
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
REVISION
1
Dated: Nov 2011
Issued By: SW
Page: 149 of 233
12.1.3 INSPECTION AND REPAIR
1.
Inspect nylon bearings for wear. Replace if worn.
2.
Inspect pedal bars for wear around bearing area and for distortion.
3.
Inspect pedals for distortion or loose rivets in end stops.
4.
Inspect bolt holes for wear and elongation.
5.
Inspect bolts and nuts for distortion and wear.
6.
Replace any distorted or worn parts.
If the optional adjustable rudder pedals are fitted these steps must also be performed:
7.
Inspect adjustment pins for wear, replace if required.
8.
Inspect adjustment pin springs and replace if required.
9.
Inspect adjustment pin pull rings for wear, replace if required.
WARNING
All spherical rod end bearings must be fitted with a large washer on the outside of the
through-bolt to prevent the bearing case and cable releasing in the event of a bearing failure.
Figure 121
– Rudder Pedal - Non-Adjustable