![background image](http://html1.mh-extra.com/html/jabiru/2200/2200_overhaul-manual_3122313120.webp)
Engine Overhaul Manual
Jabiru Aircraft
Pty Ltd
Jabiru 2200 & 3300 Aircraft Engines
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
6 7
Dated : 28/10/2014
Issued By: AS
Page: 120 of 201
L:\files\Manuals_For_Products\Engine_Manuals\Overhaul_Manual\JEM0001-7_Overhaul_Manual_DRAFT_(29_10_14).docx
7.6 Subassembly F
– Gear case and distributors
7.6.1 Engine Mount Plate & Tacho Pickup
Note that the 2200 mount plate is different from the 3300 version
– these parts cannot be interchanged.
As discussed in Section 5.13.4, for each engine there are 2 different engine mount plates available
–
one to suit the 99 tooth ring gear and another to suit the 101 tooth ring gear. It is not mandatory for
these parts to be updated on overhaul, however the parts must be matched (ring gear to engine mount
plate) for proper operation.
Fit the oil feed tubes (2
– 1 one for each distributor shaft) as shown.
The tacho pickup post (where equipped) and the gearbox locating pins can also be fitted now.
Where the hall-effect type tacho sender is used (Figure 147) it must be installed during final assembly
Figure 146
– Installation of Oil Feed Tubes & Tacho Pickup Post
Figure 147
– Hall affect Tacho Sender
Tacho post with sender installed
Oil feed tube installed in back plate.
Orient with slot pointed upwards