Step 8.
With KuDo 6T™ body tethered to the hanger wire and hanging freely you may now splice
building power. The KuDo 6T™ is equipped with a driver cover that has a removable splice plate
with two 7/8” knockouts. Access ground and power disconnect by removing splice plate. Check to
make sure building voltage matches voltage offered by the KuDo 6T™ provided on the safety label.
Splice ground wire before splicing building power wires.
4
KuDo 6T™
KuDo 6T
TM
new troffer includes driver
cover with splice plate and two 7/8”
knockouts .
Step 7.
Raise the fixture slowly
upward as it pivots on the
hinge bolts near the end of the
LIFT RAILS. Gently lift the hinge
side of the fixture body to slide
all the way up the end of the
slots on the LIFT RAILS. This
will allow the opposite edge of
the KuDo 6T™ closest you to
clear the T‐Bar face. Raise the
non‐hinge side above the T‐Bar
and slowly pull back until you
feel the hinge bolts
drop into the “Drop Slot”. The KuDo 6T™ may now be allowed to
rest on the T‐Bar (9).