J.R. Clancy SC5300, User Manual

Page: 14 / 19

SceneControl ® 5000 HARDWARE
SceneControl ® 5000 HARDWARE
12
Connecting the
SC5300 Console
To the Main System
1. BEFORE USING YOUR
SC5300 Console
BE SURE YOU UNDERSTAND AND
FOLLOW ALL BASIC SAFETY GUIDELINES AS LAID OUT BY YOUR SYSTEM
ADMINISTRATOR.
2. Ensure that the E-stop button on the
SC5300 Console
is pushed in.
3. Press and pull out the local E-stop button on the E-Stop Master Controller to disable
the system.
4. Connect the Console Power Distribution (PD) to the CONSOLE-1 Port on the
E-Stop Master Controller using the E-Stop/Data Extention Cable.
5. Pull out the Emergency Stop button on the
SC5300 Console
.
6. Turn and hold the Emergency Stop Reset Lockout key and press the E-stop Reset
button.
7. Release the Emergency Stop Reset Lockout key and E-stop Reset button.
8. The Main Emergency Stop System should now be reset.
9. Press the Emergency Stop button.
10. The Emergency Stop System should now be disabled.
11. Turn on the power switch for the
SC5300 Console Helm
using the switch on the
right hand side of the console.
12. Your
SC5300 Console
will now perform a self-diagnostic test, lamp test and boot
up.
13. You are now ready to confirm communications and use your
SC5300 Console.
14. Once you have confirmed communications, reset the Main Emergency Stop System
by following items 5, 6 and 7 above.
IMPORTANT NOTE OF CAUTION!!!
Before you operate any equipment connected to your system it is imperative that you test
your Emergency Stop and E-stop Reset buttons. Failure to do so could result in a serious
injury or even death should this equipment not be ready to function when needed.