9
Step 8 Aileron assembly and installation
▼
1. Use epoxy to glue the ball cups (aileron top and bottom connecting points) in the trailing edge of
the ailerons. Note that the ball cup holes should be facing upwards on the lower aileron (i.e. the red
side of lower ailerons) and downwards on the upper wing aileron (i.e. the green side of the upper
aileron).
Figure 11. Glue ball cups in the holes on the ailerons
▼
2. Glue the aileron hinges using a thin Cyano and fit control horns to the underside of the lower wing
as shown.
▼
3. Fit the aileron servos on the underside of the lower wing panel. When installing the wing servos,
extension leads may be needed.
Figure 12. Install aileron servos and connect push-rods
Step 9 Mount and fix the upper and lower wing panels in place
▼
1. Glue hard wood dowels into the fuselage sides then stick the black rubber strips onto the wing
saddle. (Figure 13)
▼
2. Use rubber bands to fix the upper and lower wing panels in place. Depending on the rubber
bands used, you will need at least 4 bands per wing.
