8
When installing a sink or cooktop, trimming the top support
rails may be necessary. Using the template supplied by the
sink or cooktop manufacturer, cut the top rails as required
using a jigsaw.
SINK/COOKTOP INSTALLATION
BASE AND BASE BLIND CORNER CABINETS
BBC (base blind corner) cabinets may be pulled out from the corner if required and the room is
available. When installing a base cabinet at a right angle to a BBC cabinet you must use a filler
to provide clearance for door and drawer handles. The filler width required is usually 1 3/4" - 3"
depending on the type of pull used on the cabinets. Cut the 3" filler to required width. Fasten the
filler to the two adjacent cabinets by drilling through the side of the cabinet into the filler. Screw
together. Ensure cabinets are square in corner and attach the unit to the wall. Make sure all
cabinets are plumb and level. The remaining base cabinets are installed in the same manner.
Using the two C-clamps, align stiles, drill and screw together. Proceed around the room making
sure all cabinets are plumb and level, shimming where necessary, then tighten all screws.
• Minimum 42 3/4"
does not allow
for filler/hardware
clearance.
• Maximum
45 3/4" is with
3" filler attached
to be flush with
the door. Filler not
included.
30"
18"
Filler
Trim this
side of
the filler
to make
it fit
#8 x 1 1/2"
screws
Install the remaining base cabinets by aligning the front of the cabinet edges. Clamp the
cabinets together and attach using the 1 1/8" screws. Level the cabinet, adjust as required, and
attach to the wall studs using 2 1/2" screws through the hanging rail located at the top of the
base cabinet. After inserting the screws remove the clamps.
Summary of Contents for W1830
Page 1: ...INSTALLATION GUIDE...
