20
Volcan B12 - KILAUEA
IMPORTANT: Starting point is located
At the bottom of the fireplace
Figure D
1
Tools required: Reciprocating
saw, measuring tape, level,
pencil, eraser, Square tip #2
screwdriver, 4 screws of 1 ½
inches and 4 anchors
2
Mark the starting point
see figure D
using the pencil and
measuring tape.
3
Draw a 26 inches horizontal
line using the level.
4
From the starting point
mark a dot at 14.3 inches
on each side on your
horizontal line.
5
Starting from each dot,
you draw up a vertical
line of about 26 inches.
6
Starting again from each
dot on the horizontal line
mark a dot at 23 5/8
inches on each vertical
line.
7
Draw a horizontal line
using the level closing up
your square
8
Make a hole on the wall
following the lines you
have drawn.
9
Insert the fireplace.
10
Secure the fireplace with
the screws in the holes
located at the bottom of
fireplace.
11
Install the surround
decorative moulding
Not included
When in doubt, have it installed by a specialist
Summary of Contents for volcan b12 vesuve
Page 24: ...24 FIGURE G...
