J. A. Roby PIONEER, Manual

Page: 13 / 37

PR_I017/2023-01-23-EN
13
Assembly before installation
Depending on the option you chose, the stove legs and air entry
box (4 inches/10.1cm) might not have been assembled in the
shop in order to save space for storage and shipping. You must
therefore assemble them before installing the stove.
Air entry box installation
1) Remove legs air entry box and bricks from combustion room.
2) Unscrew the stove from the skids.
3) Put the stove on the back and be careful to protect the paint.
4) Insert the air entry box and tighten 4 screws to fix the box.
Legs installation
1) Unscrew the nut (#4) at the corners with removing
completely.
2) Install the legs (#1) as illustrated and secure it with nut, lock
washer and washer (#2, #3, #4) (Attention: Be sure the legs
are in place, correctly positioned and in contact with the
bottom
of the stove.)
Fan and Snap disc box installation
The efficiency of the appliance can be lower than the
specification when the blower is not in function or is not
installed.
1) Screw the fans on the 75 cfm fan box as illustrated.
Make sure to place the cables as shown.
2) Screw the heating box and snap disc box into the holes
made for that at the back side near the vent box.
3) To install a 460 cfm fan , put the snap disc box as the
same as the installation above.
4) Remove the access panel (1) rear of the fan box (3
screws) to insert 4 lock washers and 4 nuts.
5) Put the fan in position and pass the bolt through the fan
and box and tight with the lock washer and nut. Put the
access panel at the good place.