12
STARTING
A technician should do the first lighting
Before proceeding to the first lighting, make sure that all parts are in place (figure 1),
that the connection to the chimney is secure and that all oil supply conduct joints are
tight.
1.
Push down the ON/OFF switch to ON.
2.
Turn the control button to 1.
3.
Open the oil supply.
4.
Wait until the oil gets to the burner, then light it using a long match and close the
door.
5.
Wait at least 15 minutes to change the oil flow. To be done by a technician.
6.
Adjust draught regulator with counterweight. When the appliance gets to its
maximum "6", that the chimney is hot and outside temperature is calm, the
draught regulator must be closed up to the opening limit. To be done by a
technician.
To turn off the appliance, put back the control button to the position "0". If the
appliance is not in service for a long period, it is strongly recommended to place the
carburetor in position OFF and to close the arrival of oil.
WARNING!
W
HILE THE APPLIANCE IS IN FUNCTION
,
KEEP AWAY
CHILDREN
,
CLOTHING AND FURNITURE
.
NOTES:
Before every lighting, make sure there is no oil excess at the bottom of the burner.
If there is an excess of oil, it must be sponge up before lighting to avoid stove damages.
NEVER TRY TO LIGHT UP THE APPLIANCE WHILE HOT.
During the first hours of utilisation of your oil stove, it is normal to perceive a light
burnt paint odor. Although it is temporary, it is preferable to air well.
Summary of Contents for JUNIOR 8" Oil1
Page 6: ...6 APPLIANCE PARTS Figure 1...
