USB Smart Cable
User Manual
UM018115-1016
USB Smart Cable
6
2. Select
Install from a list or specific location (Advanced)
, then click
Next
. If the Windows Logo testing dialog appears, select
Continue
Anyway
.
3. Select
Search for the best driver in these locations
and
Include
this location in search:
, then locate and click the following direc-
tory:
<ZDS installation>\device drivers\USB\x32
4. Click
Next.
After the appropriate driver information has been found,
click
Next
a second time.
5. Click
Finish
to complete the installation.
Connecting to the Target Board
Important!
Observe the following steps to complete the power-on
sequence before connecting to the target board.
1. Connect the USB Smart Cable to the host PC.
2. Attach one end of the six-conductor ribbon cable to the Smart Cable
six-pin DBG connector, as shown in Figure 1. Attach the free end of
the ribbon cable to the connector on the target board. Ensure that pin
1 on the ribbon cable (indicated by the dark stripe) is aligned with pin
1 on the target connector.
3. Apply power to the target board. If the target is not connected prop-
erly, remove the USB Smart Cable from the host PC and repeat the
preceding steps. If the connection is problematic, refer to the Trouble-
shooting Tips section on page
.
